The cylindrical tube of a spray pump has radius R, one end of which has n fine holes, each of radius r. If the speed of the liquid in the tube is v, the speed of the ejection of the liquid through the holes is
1.
2.
3.
4.
The weight of an aeroplane flying in the air is balanced by
(1) Vertical component of the thrust created by air currents striking the lower surface of the wings
(2) Force due to reaction of gases ejected by the revolving propeller
(3) Upthrust of the air which will be equal to the weight of the air having the same volume as the plane
(4) Force due to the pressure difference between the upper and lower surfaces of the wings created by different air speeds on the surfaces
Equation of continuity based on :
1. Conservation of mass
2. Conservation of energy
3. Conservation of angular momentum
4. None of these
The area of cross-section of the wider tube shown in the figure is If a mass of 12 kg is placed on the massless piston, then the difference in heights h of the levels of water in the two tubes will be:
1. | 10 cm | 2. | 6 cm |
3. | 15 cm | 4. | 2 cm |
Water flows through a frictionless duct with a cross-section varying as shown in the figure. Pressure p at points along the axis is represented by
1. 2.
3. 4.
A small spherical solid ball is dropped in a viscous liquid. Its journey in the liquid is best described in the figure by :
1. Curve A
2. Curve B
3. Curve C
4. Curve D
The flow rate from a tap of diameter 1.25 cm is 3 lit/min. The coefficient of viscosity of water is Pas. The nature of flow is :
1. Turbulent
2. Laminar
3. Neither laminar nor turbulent
4. data inadequate
The radius of a soap bubble is increased from R to 2 R. Work done in this process (T = surface tension) is:
1. | 24 πR2T | 2. | 48 πR2T |
3. | 12 πR2T | 4. | 36 πR2T |
If there were a smaller gravitational effect, which of the following forces do you think would alter in some respect?
(1) Viscous forces
(2) Archimedes uplift
(3) Electrostatic force
(4) None of the above
A U tube with both ends open to the atmosphere,is partially filled with water. Oil, which is immiscible with water, is poured into one side until it stands at a distance of 10mm above the water level on the other side. Meanwhile the water rises by 65 mm from its original level (see diagram). The density of the oil is
(a)
(b)
(c)
(d)