The resistance of an ideal voltmeter is 

(1) Zero

(2) Very low

(3) Very large

(4) Infinite

Constantan wire is used in making standard resistances because of its :

(1) Specific resistance is low

(2) Density is high

(3) Temperature coefficient of resistance is negligible

(4) Melting point is high

The net resistance of a voltmeter should be large to ensure that :

A potentiometer consists of a wire of length 4 m and resistance 10 Ω. It is connected to a cell of e.m.f. 2 V. The potential difference per unit length of the wire will be :

(1) 0.5 V/m

(2) 2 V/m

(3) 5 V/m

(4) 10 V/m

In the circuit shown $P\ne R$, the reading of the galvanometer is same with switch S open or closed. Then 

(1) $I_R=I_G$

(2) $I_P=I_G$

(3) $I_Q=I_G$

(4) $I_Q=I_R$

In the following Wheatstone bridge $P/Q=R/S$. If key K is closed, then the galvanometer will show deflection :

(1) In left side

(2) In right side

(3) No deflection

(4) In either side

A galvanometer having a resistance of 8 ohms is shunted by a wire of resistance 2 ohms. If the total current is 1 amp, the part of it passing through the shunt will be :

(1) 0.25 amp

(2) 0.8 amp

(3) 0.2 amp

(4) 0.5 amp

In a potentiometer experiment, the galvanometer shows no deflection when a cell is connected across 60 cm of the potentiometer wire. If the cell is shunted by a resistance of 6 Ω, the balance is obtained across 50 cm of the wire. The internal resistance of the cell is 

(1) 0.5 Ω

(2) 0.6 Ω

(3) 1.2 Ω

(4) 1.5 Ω

A voltmeter of resistance 1000 Ω gives full-scale deflection when a current of 100 mA flow through it. The shunt resistance required across it to enable it to be used as an ammeter reading 1 A at full-scale deflection is :

(1) 10000 Ω

(2) 9000 Ω

(3) 222 Ω

(4) 111 Ω

In the circuit given below, the e.m.f. of the cell is 2 volt and the internal resistance is negligible. The resistance of the voltmeter is 80 ohm. The reading of the voltmeter will be:                                 
1. 0.80 volt

2. 1.60 volt

3. 1.33 volt

4. 2.00 volt