Find out the value of current through 2Ω resistance for the given circuit
(1) 5 A
(2) 2 A
(3) Zero
(4) 4 A
Two sources of equal emf are connected to an external resistance R. The internal resistances of the two sources are R1 and . If the potential difference across the source having internal resistance R2 is zero, then
(1)
(2)
(3)
(4)
The magnitude of i in ampere unit is
(1) 0.1
(2) 0.3
(3) 0.6
(4) None of these
To draw maximum current from a combination of cells, how should the cells be grouped
(1) Series
(2) Parallel
(3) Mixed
(4) Depends upon the relative values of external and internal resistance
By ammeter, which of the following can be measured
(1) Electric potential
(2) Potential difference
(3) Current
(4) Resistance
The resistance of 1 A ammeter is 0.018 Ω. To convert it into 10 A ammeter, the shunt resistance required will be :
(1) 0.18 Ω
(2) 0.0018 Ω
(3) 0.002 Ω
(4) 0.12 Ω
For measurement of potential difference, the potentiometer is preferred in comparison to the voltmeter because:
1. the potentiometer is more sensitive than the voltmeter.
2. the resistance of the potentiometer is less than
the voltmeter.
3. the potentiometer is cheaper than the voltmeter.
4. the potentiometer does not take current from the circuit.
The potential gradient along the length of a uniform wire is 10 volt/metre. B and C are the two points at 30 cm and 60 cm point on a meter scale fitted along the wire. The potential difference between B and C will be :
(1) 3 volt
(2) 0.4 volt
(3) 7 volt
(4) 4 volt
In Wheatstone's bridge P = 9 ohm, Q = 11 ohm, R = 4 ohm and S = 6 ohm. How much resistance must be put in parallel to the resistance S to balance the bridge
(1) 24 ohm
(2) ohm
(3) 26.4 ohm
(4) 18.7 ohm
A potentiometer is an ideal device of measuring potential difference because
(1) It uses a sensitive galvanometer
(2) It does not disturb the potential difference it measures
(3) It is an elaborate arrangement
(4) It has a long wire hence heat developed is quickly radiated