A cubical block of wood 10 cm on a side floats at the interface between oil and water as shown in figure with its lower face 2 cm below the interface. The density of oil is 0.6 gm/cm³. The mass of the block is

1. 600 gm

2. 680 gm

3. 800 gm

4. 200 gm

Angle of contact of a liquid with a solid depends on

1. solid only

2. liquid only

3. both on solid and liquid only

4. orientation of the solid surface in liquid

A U-tube is partially filled with water. Oil which does not mix with water is next poured into one side, until water rises by 25 cm on the other side. If the density of oil is 0.8, the oil level will stand higher than the water level by

1. 6.25 cm

2. 12.50 cm

3. 31.75 cm

4. 62.50 cm

Two solid spheres of same metal but of mass M and 8M fall simultaneously on a viscous liquid and their terminal velocities are v and nv, then value of n is 

1. 16

2. 8

3. 4

4. 2

A liquid will not wet the surface of a solid, if the angle of contact is

1. 0$°$

2. 45$°$

3. 60$°$

4. >90$°$

Drops of a liquid are usually more spherical in shape than larger drops of same liquid because

1. force of surface tension is equal and opposite to force of gravity

2. force of surface tension predominates the force of gravity

3. force of gravity predominates the force of surface tension

4. force of gravity and surface tension are equal and in same direction

A vessel whose bottom has a round hole with diameter 0.1 mm, is filled with water. The maximum height upto which water can be filled without leakage is

(Surface tension of water =75 dyne/cm and g = 1000 cm s^-2)

1. 100 cm

2. 75 cm

3. 50 cm

4. 30 cm

A spherical liquid drop of radius R is divided into eight equal droplets. If surface tension is T, then the work done in this process will be

1. $2\pi R^{2}T$

2. $3\pi R^{2}T$

3. $4\pi R^{2}T$

4. $5\pi R^{2}T$

There are two hole $O_1 and O_2$ in a tank of height H . The water emerging from $O_1 and O_2$ strikes the ground at the same points, as shown in figure. Then

1. $H=h_1+h_2$

2. $H=h_2-h_1$

3. $H=\sqrt{h_1{h}_2}$

4. None of these

With the increase in temperature, the surface tension of a liquid

(1) increases

(2) decreases

(3) remains the same

(4) changes erratically